VERSA PAINTBALL GEAR

SPO Gear's new innovative VERSA SHELL SYSTEM is unlike any other in paintball. Its versatile design and sturdy construction takes it to another level.

 

Remove shell from packaging and disassemble shell, saving all screws, noting screw size and location, nuts and plastic bag of small parts. The two small cylindrical spacers and two screws in the plastic bag are not necessary for use with the Versa Shell.

Remove lid-retaining latch from shell half.

Vlocity & Vlocity Jr.

1.  Remove reset button extender from small plastic bag and slide over Vlocity reset button.

*TIP- Due to slight variations in manufacturing tolerances, the Vlocity reset button may not be centered in the hole provided in the left half shell resulting in the button not moving freely. If so, enlarge the hole with a 13/64” drill bit.

2.  Install Vlocity collar adapters. The adapters may be installed on the feed neck or may be installed in each shell half independently. Collar tabs should be centered at the front and pointed upward.

3.       Insert the Vlocity loader assembly into the left half shell, rear first, taking care   

 not to bend or break the reset button.

4.  Slide the right side shell into place making sure that the battery leads are routed through the provided slot and do not get pinched.

5.  Make sure that the battery cover screw retention nut is in place and replace the housing screws.

* TIP- Attach batteries and test loader functions before installing final screws.

6.  Insert the lid-retaining latch into the slot at the rear of the filler opening. It will snap/lock into place.

7.       Snap the top lid assembly and/or the Tournament Adapter into place starting with the front lip first then snapping the rear into place.

8.       Attach the battery cover with the shortest of the four screws.

 

Halo B, Reloader B and Magna Loader.

1.  Insert catch cup into the cup adapter so that the feed neck is even with or                              

     slightly extending past the adapter feed neck.

*  TIP- You may have to remove one or two layers of tape covering the eyes on 

                 the Halo version to allow proper seating of the unit in the cup adapter.

2.       Slide the PC board into the slot of left half shell at the rear.

3.       Slide cup adapter assembly into the left half shell so that the catch cup slides under the lower shelf.

4.       Slide the right half shell into place taking care that the PC board aligns with the slot and the wiring doesn’t become unplugged, making sure that the battery leads are routed through the provided slot and do not get pinched. The catch cup must fit under the right shell half shelf.

5.  Make sure that the battery cover screw retention nut is in place and replace the                

     housing screws.

* TIP- Attach batteries and test loader functions before installing final screws.

6.  Insert the lid-retaining latch into the slot at the rear of the filler opening. It will    

     snap/lock into place.

7.  Snap the top lid assembly and/or the Tournament Adapter into place starting    

     with the front lip first then snapping the rear into place.

8.  Attach the battery cover with the shortest of the four screws.